1) La descarga del recurso depende de la página de origen
2) Para poder descargar el recurso, es necesario ser usuario registrado en Universia


Opción 1: Descargar recurso

Detalles del recurso

Descripción

Plasticization phenomena can significantly reduce the performance of polymeric membranes in high-pressure applications. Polyetherimides (PEIs) are a promising group of membrane materials that combine relatively high CO2/CH4 selectivities with high chemical and thermal stability. In this work sorption, swelling, and mixed gas separation performance of 3,3′,4,4′-oxydiphthalic dianhydride (ODPA)-based PEI polymers, with 1, 2 or 3 para-aryloxy substitutions in the diamine moeiety, is investigated under conditions where commercial membranes suffer from plasticization. Particular focus is on the influence of the amount of para-aryloxy substitutions and the film thickness. Results are compared with those of commercially available polymeric membrane materials (sulphonated PEEK, a segmented block-co-polymer PEBAX and the polyimide Matrimid). The glassy polymers display increasing CO2 sorption with increasing Tg. The larger extent of sorption results from a larger non-equilibrium excess free volume. Swelling of the polymers is induced by sorption of CO2 molecules in the non-equilibrium free volume as well as from molecules dissolved in the matrix. Dilation of the polymer is similar for each molecule sorbed. Correspondingly, the partial molar volume of CO2 is similar for molecules present in both regions. Mixed gas separation experiments with a 50/50% CO2/CH4 feed gas mixture showed high CO2/CH4 selectivities for the ODPA PEI films at elevated pressure. This shows that these materials could potentially be interesting for high-pressure gas separation applications, although additional gas permeation experiments using different feed gas compositions and thin films are required.

Pertenece a

University of Twente Publications  

Autor(es)

Simons, Katja -  Nijmeijer, Kitty -  Guilera Sala, Jordi -  Werf, Hans van der -  Benes, Nieck E. -  Dingemans, Theo J. -  Wessling, Matthias - 

Id.: 55226548

Versión: 1.0

Estado: Final

Tipo:  application/pdf - 

Tipo de recurso: Article / Letter to editor  - 

Tipo de Interactividad: Expositivo

Nivel de Interactividad: muy bajo

Audiencia: Estudiante  -  Profesor  -  Autor  - 

Estructura: Atomic

Coste: no

Copyright: sí

: © 2010 Elsevier

Formatos:  application/pdf - 

Requerimientos técnicos:  Browser: Any - 

Relación: [References] http://doc.utwente.nl/80177/1/Dingemans10sorption.pdf

Fecha de contribución: 26-oct-2016

Contacto:

Localización:

Otros recursos del mismo autor(es)

  1. Dry–wet phase inversion block copolymer membranes with a minimum evaporation step from NMP/THF mixtures Block copolymer (BCP) membranes are a very promising new type of membranes, but often have a difficu...
  2. Weak polyelectrolyte multilayers as tunable membranes for solvent resistant nanofiltration This manuscript encompasses the investigation into the solvent resistant nanofiltration (SRNF) perfo...
  3. Dealing with inaccuracies in the analysis on solvent-induced swelling of transparent thin films using in situ spectroscopic ellipsometry in the visible wavelength range The accuracy of spectroscopic ellipsometry studies of transparent polymer films in the visible wavel...
  4. The mechanical strength of a ceramic porous hollow fiber The mechanical strength of inorganic porous hollow fibers is a critical constraint that limits their...
  5. Interfacial polymerization of cyanuric chloride and monomeric amines: pH resistant thin film composite polyamine nanofiltration membranes Polyamine nanofiltration membranes have a high stability at extreme pH conditions. In contrast to po...

Aviso de cookies: Usamos cookies propias y de terceros para mejorar nuestros servicios, para análisis estadístico y para mostrarle publicidad. Si continua navegando consideramos que acepta su uso en los términos establecidos en la Política de cookies.